Db300A Rear Panel - Samson dB300a Owner's Manual

dB300a REAR PANEL

– Used to adjust the volume of the
1
MIC LEVEL
microphone input.
Dual color LED lights Green when
2 AMP / CLIP LED -
amp is active, flashes Red when the amp is clipped
or stays Red indicating the amplifier is in protect
mode.
– Used to control the level of the line
3
LINE LEVEL
input.
- Controls the low band
4
LOW FREQUENCY
of the Channel Equalizer, +/- 12 dB at 100Hz.
- Controls the high band of the
5
HIGH FREQUENCY
Channel Equalizer, +/- 12 dB at 10kHz.
OUTPUT SWITCH - This switch is used to select the sig-
6
nal that is sent to the Line Output. When the switch is in
the up position, the signal on the Line Output is exactly
the same as the signal on the Input. When the switch
is in the down position the Line Output carries the MIX
of the Mic and Line Inputs, as well as the High and Low
Equalizer and Low Filter.
When engaged, a Low-cut
7 LOW FILTER SWITCH -
filter is employed at 80Hz with a roll-off slope of 12
dB per octave.
8 LINE INPUT CONNECTOR
Input for connecting balanced or unbalanced line
level signals.
HEAT SINK - Convection cooling of the internal power
9
amplifier via massive aluminum extrusion.
– Switches on the dB300a's main power.
10 POWER
– Connect the supplied standard
11
AC POWER INLET
IEC AC power cable here.
12 LINE OUTPUT - Male XLR connector used to link
multiple dB300a's.
13 MIC INPUT CONNECTOR - XLR Input for connecting low
impedance microphones to the Low-Noise pre-amp and
Phantom Power.
- Red LED illuminates when the Mic input
14 PEAK LED
receives a clipped signal.
- Combo XLR plus 1/4 inch
dB300a Rear Panel Layout
1 2 3
14
13
12
11
5
dB300a Layout
4
10
5
6
7
8
9