Samson XP150 Owner's Manual
  1. Manuals
  2. Brands
  3. Samson Manuals
  4. Speakers
  5. EXPEDITION XP150
  6. Owner's manual

Samson XP150 Owner's Manual

Expedition
Hide thumbs Also See for XP150:

Advertisement

Table of Contents

See also: Owner's Manual
Owner's Manual

Advertisement

Table of Contents
loading

Related Manuals for Samson XP150

Summary of Contents for Samson XP150

  • Page 1 Owner’s Manual...
  • Page 2 ABS high impact plastic, making it super road tough and, at the same time, light- weight. In this manual, you’ll find a detailed description of the features of the XP150 PA system, as well as a description of its front and rear panels, step-by-step instructions for its setup and use, and full specifications.
  • Page 3 Features • The XP150 is a compact PA system with dual 2-way speakers, onboard mixer, and 150 watt power amplifier. • The XP150 is the ultimate in portability. The lightweight, clever design allows you to slide and lock the two speakers together to carry all components together in a single, easy to move case.
  • Page 4 Setting Up the XP150 Unpack all the system components from the shipping carton and save all packing materials in the event your unit ever needs to be returned for service. Remove the mixer by turning the quarter turn screw counterclockwise towards the RELEASE position.

  • Page 5: Setting Up The Xp150

    Setting Up the XP150 Replace the accessory panel by aligning the bottom of the panel with the slots. Make sure the quarter turn screw is in the RELEASE position; then close the panel and turn the quarter turn screw clockwise to LOCK.
  • Page 6 Turn each of the channel volume (VOL) and MASTER volume controls fully coun- terclockwise, to the “0” position. Next, connect one side of the included power cable to the XP150 mixer’s power inlet and the other to a grounded AC power outlet.

  • Page 7: Xp150 Quick Start

    XP150 Quick Start Start talking or playing into channel 1 while slowly adjusting the VOL control until you have reached the desired level. Do the same for each channel you are using. If you notice that the POWER/PEAK indicator is lighting constantly, turn the MASTER volume down so that the indicator only lights occasionally.

  • Page 8: Configuring The Xp150 For Transport

    You can easily carry your sound system using the XP150’s “Slide and Lock” feature. The “Slide and Lock” speaker enclosures allow you to connect both speakers together into a single, easy to carry unit. Follow these steps to configure the XP150 for easy trans- port.

  • Page 9: Xp150 Mixer Layout

    XP150’s built-in mic preamps. ¼-inch Line Input Connectors (channels 1-3) – Use these ¼” jacks to connect instrument or audio sources with line level signals to the XP150. You can connect the outputs from acoustic guitar pickups, keyboards, drum machines, CD/MP3 players and other units with line level outputs here.
  • Page 10 Left and Right output jacks (see #10 above). 14. POWER Switch – Use the POWER switch to turn power to the XP150 on or off. 15. Power/Peak Indicator – This LED will illuminate GREEN when the MAIN power switch is turned on, and light RED when the when the amp is near the clipping point.
  • Page 11 XP150 Connections Expedition XP150...

  • Page 12: Xp150 Wiring Guide

    XP150 Wiring Guide There are several ways to interface the XP150 to support a variety of applications. The XP150 features balanced inputs, so connecting balanced and unbalanced signals is possible. Unbalanced ¼” Connector Signal Signal Tip (signal) Ground Ground Sleeve (ground) Stereo TRS 3.5mm Connector...

  • Page 13: Specifications

    100Hz Shelving ±15 dB Speech/Music Switch 150Hz, 18dB/Octave Indicators Two Color LED - Power/Peak Dimensions and Weight Length 15.6”/395 mm Dimensions Width 8.6”/218 mm Height 13.9”/354 mm Weight 24 lbs/10.8 kgs Specifications are subject to change without notice. Expedition XP150...

  • Page 14: Block Diagram

    Block Diagram Owner's Manual Expedition XP150...

Table of Contents