Modes In The Receiver Dt10; Output For User With Different Input Types And; Programs In The Hearing Instrument - Comfort Digisystem DT10 User Manual

7) Listening modes in the Receiver DT10
The available listening modes in the Receiver DT10
can be setup in different configurations:
R Default setting
R+M
Setup with Programmer DT05
is necessary
R and R+M
Setup with Programmer DT05
is necessary
The Programmer DT05 is used to configure and enable
or disable different listening modes in the Receiver
DT10. The push-button on the Receiver DT10 is used to
toggle between the activated listening modes.
It is also possible to disable the push-button completely.
8) Output for user with different input types and programs in the hearing instrument
Different hearing instrument electrical input types and available programs in the hearing instrument will result
in different output for the user. Output for the user is shown in the white sections of the charts below.
Receiver DT10 with R mode enabled (default setting)
The chart below shows the output (what the user can hear) when Receiver DT10 listening mode R is enabled in
combination with different input types and programs in the HI.
When pressing the push button on the Receiver DT10, the listening mode is shifted in the following sequence:
Hearing instrument:
DAI input
Programmable DAI input
(DPAI)
DAI + M program
Programmable DAI input
(DPAI)
DAI program only
Receiver DT10 push-button
Off
Off
Off Radio + HI microphone
Off
Receiver DT10
R mode
Radio only
Radio only
6