Table of Contents
Advertisement
Pairing
When Pairing is selected, the DT10 can be set to pairing
mode by pressing the push-button for two seconds.
If Pairing isn't selected, pairing mode cannot be enabled
with the push-button. To override this, (if the Receiver
DT10 needs to be reconfigured or if new pairing infor-
mation needs to be received), press and hold the push-
button on the Receiver DT10 for 2 seconds within
10 seconds of it having been connected to a hearing
instrument or a Programmer DT05. This sets the
Receiver DT10 to Pairing mode and it is then ready to
receive new settings from the Programmer DT05.
Always on
The setting Always on , disables the off-function of the
push-button, leaving the Receiver DT10 always on.
If you enable Always on and at the same time disable
Pairing , the push-button on the Receiver DT10 becomes
inoperable.
Send all
To configure a Receiver DT10 with all settings in the
display of the Programmer DT05 select Send all. If you
choose Send all, you will receive the warning "All set-
tings in DT10 will be overwritten". Only select Yes if you
want to overwrite all data in your Receiver DT10.
Settings
Language
For selection of menu language.
Factory Reset
DT05: Resets the Programmer DT05 to its default
settings.
DT10: Resets the Receiver DT10 to its default
settings. Also deletes all pairing information.
To prevent eaves-dropping a new code key must be
generated.
About
Software information.
13) Battery maintenance Programmer DT05
The rechargeable products in the Digisystem series are
equipped with Li-Pol batteries, ie. the same type of
batteries used for most mobile phones and laptop
computers on the market today. These types of batteries
are able to store large amount of energy in relation to
their weight and volume.
The capacity of Li-Pol batteries diminishes during its life
cycle. The battery type has no "memory effect", which
would mean that you need fully discharge the battery
before charging to minimize capacity loss. This means
that you can just as well charge the battery often and
little, as opposed to seldom and much. Special charg-
ing circuits in the Digisystem products protect batteries
from overcharging.
The capacity of the Li-Pol batteries deteriorates faster
when they subjected to deep discharge. Therefore, all
products of the Digisystem are fitted with a function that
automatically turns off the product well before deep
discharge occurs. Deep discharge may still happen as
the battery has a certain self-discharge. A product that
is fully or partly charged will with enough time reach
a state when the battery deep discharges, unless the
charger is connected. To avoid this we recommend that
the battery is charged at least every 6 months.
Please note:
Only use the charger supplied by Comfort Audio.
Changing the battery without the assistance of an
authorized dealer will void the Limited Warranty.
14) Technical data Receiver DT10
Radio transmission:
Frequency range:
Range:
Dimensions:
Weight:
4002355
The weights, dimensions, capacities, performance ratings and other data in
Comfort Audio's brochures, prospectus, circulars, advertisements, price lists and
instructions sheets are mentioned only as general information. They are only ap-
proximate and shall not bind Comfort Audio.
Receiver DT10
SST - SecureStream
Technology
904 - 927 MHz
Approx. 50 feet (15 m)
0,38 x 0,44 x 0,84 inches
(9,7 x 11,2 x 21,3 mm)
0,05 oz (1,5 g)
Conforms to ANSI/UL Std.60065
Certified to CAN/CSA Std.C22.2 No.60065:03
11
Advertisement
Table of Contents
