Table of Contents
Advertisement
Programmer DT05
The Programmer DT05 is an optional professional tool
that can be used both for configuring and test-listening
of the DT10.
The Programmer DT05 can be used to configure one
setting at a time in the Receiver DT10. Select the desired
setting in the menu and double press the pairing button.
The Receiver DT10 must be set to pairing mode.
The Programmer DT05 can also be used to configure all
settings at the same time in a DT10. To do this, adjust all
parameters in the DT05 and then select Send all on the
DT05 menu. The Receiver DT10 must be set to pairing
mode.
When using the Programmer DT05 for configuring
the distance between the Programmer DT05 and the
Receiver DT10 should not exceed 0.5 meters.
To listen to a DT10, plug it into the socket on the
programmer and connect headphones or a neck-loop.
Menu control
Scroll up
Press / select
Scroll down
To access the menu, press the menu control and then
scroll up or down.
Press the menu control to select.
12) Menu in the Programmer DT05
R enable
R
R+M enable
R+M
Tone ind.
Auto sleep
Pairing
Always on
Send all
Settings
- Language
- Factory Reset
About
Back
(relates to both the main menu and submenus)
Here you can choose to return to the menu and to the
main display.
R enable
Enables selection of R mode with the push-button.
R
Adjusts the output level of the Receiver DT10 when
using R mode.
R+M enable
Enables selection of R+M mode with the push-button.
R+M
Adjusts the output level of the Receiver DT10 when
using R+M mode.
Tone ind.
Activates acoustic indication tones when selected.
Indication for pairing mode and pairing is always heard
even if Tone ind. is disabled.
Auto sleep
When Auto sleep is enabled the Receiver DT10 goes into
sleep mode if the Digisystem Microphone (transmit-
ter), is turned off. This significantly reduces the power
consumption of the Receiver DT10. The Receiver DT10
automatically starts again when you turn on your micro-
phone.
Warning!
If the Receiver DT10 is in sleep mode and
another radio signal (with the same frequency that you
are using) is present, the Receiver DT10 might start again
automatically. This could cause a loud hissing noise and
that's why Auto sleep should be used with caution.
Receiver DT10
10
Advertisement
Table of Contents
