Yamaha YZF600RS Owner's Manual page 56

PERIODIC MAINTENANCE AND MINOR REPAIR
WARNING
Never attempt to remove the radiator
cap when the engine is hot.
1. Radiator cap
6
7. Place a container under the engine
to collect the used coolant.
8. Remove the water pump drain bolt
to drain the cooling system.
9. Remove the cylinder drain bolts to
drain the cooling system.
EWA10380
1. Water pump drain bolt
2. Cylinder drain bolt
10. Remove the coolant reservoir by
removing the screws.
1. Screw
2. Coolant reservoir
11. Remove the coolant reservoir cap,
and then turn the coolant reservoir
upside down to empty it.
12. After the coolant is completely
13. Install the coolant reservoir by in-
14. Install the water pump drain bolt
15. Pour the specified amount of rec-
16. Pour the recommended coolant
6-16
drained, thoroughly flush the cool-
ing system with clean tap water.
stalling the screws.
and cylinder drain bolts, and then
tighten them to the specified
torques.
Tightening torques:
Water pump drain bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
Cylinder drain bolt:
7.0 Nm (0.7 m·kgf, 5.1 ft·lbf)
ommended coolant into the reser-
voir to the maximum level mark,
and then install the coolant reser-
voir cap.
into the radiator until it is full, and
then install the radiator cap.