Operation; Power On; Playing A Cd; Playing A Different Track - SPHINX Project 32 User Manual

5. OPERATION

Connect the mains cable to a mains outlet.
Once you have finished connecting all components,
you can power on the Project Thirty-two with the
mains switch O / I (27).
After switching on the display will light, show some
information and then shows " - ".
The CD player is now in Standby mode.
From now on you should switch the CD player on or
off with the STANDBY button (6).
That way all circuits will remain at optimum
operating temperatures and the audio quality will be
100% immediately after switching on. Additionally it
significantly increases the life span of the
component.

Power on

Switch the Project Thirty-two on with the STANDBY
button. The display shows:
SPHINX PROJECT 32
It will check whether there is an CD in the tray:
READING DISC
If no CD is found the display shows:
NO DISC

Playing a CD

Press the OPEN button (4): the tray opens.
Place a CD in the tray en close it by pressing the
CLOSE button (4) or PLAY button (9).
The display now shows the total number of tracks
(max. 99) and to the right the total playing time of
the CD in minutes:seconds.
Pressing the PLAY button (9) again will start the
replay of Track 1. The display now shows the actual
track number and to the right the playing time of the
track (Track Time). This time display will increase
during replay of the CD track.
All tracks will be played sequentially in the normal
order.
SPHINX

Playing a different track

If you would like to play another track then you may
select it in a number of ways.
l Each press on the NEXT button (10) will select the
next (higher number) track.
l Each press on the PREV button (8) will select the
previous (lower number) track.
From Track 1 you select the last track on the CD
with one button push.
The display shows the new track number.
l From the Remote you may directly select the track
number with the 1-0 buttons (for more information,
see page 12).

Fast search in a track

To 'search' forward or backward in a track you
should hold the NEXT or PREV button depressed.

To temporarily halt Play (PAUSE)

All Play modes can be temporarily interrupted with
the PAUSE button (9).
Pressing the PLAY button (9) will resume Play
mode.

To stop Play (STOP)

Pressing the STOP button (4) during any mode will
de-activate this mode completely, the CD will stop
and the display will show the same CD data as right
after placing a new CD in the tray.
If you now press the OPEN button (4) the tray will
open.

Power off

You switch the Project Thirty-two off (to standby)
with the STANDBY button (6).
Project 32
8