Sphinx Control; Repeat; Output Level - SPHINX Project 32 User Manual

SPHINX Project 32
Another press on the SETUP button selects:
CONTROL-IN: ON

Sphinx Control

Here you may select whether the Project Thirty-two
should react to incoming Standby commands from
other Sphinx equipment ("ON") or that it will remain
switched on ("OFF").
Another press on the SETUP button selects:
REPEAT: Off

Repeat

Here you may select whether the CD will play Track
1 again after finishing the last track or whether the
replay will stop: "OFF".
Another press on the SETUP button selects:
OUTPUT: 0 dB

Output Level

This special mode enables you to attenuate the
output level by 6 dB. In some cases this might be
necessary - for instance when the input sensitivity of
the pre-amp is very high – to prevent possible
distortion on signal peaks.
OUTPUT: -6 dB
This mode is unique while the actual attenuation is
done in the digital domain! This will ensure
maximum signal integrity.
Another press on the SETUP button ends the Set-up
mode. The display now shows the same information
as on the moment you pressed the SETUP button
for the first time.
Note: You may end Set-up mode at any time by
pressing the STANDBY button.
10