Battery Installation - EB Excalibur Sky Runner User Manual

This product requires the following batteries:
• 1 x 3.7V rechargeable Li-Poly battery - Helicopter (included)
• 6 x AA batteries - Controller (not included)
INSTALLING BATTERIES IN THE CONTROLLER
1. Using a Phillips-head screwdriver, remove the screw from the battery
compartment cover.
2. Insert six (6) AA batteries, making sure to follow the battery polarity
(+ and -) as shown in the drawing on the product.
3. Replace the battery compartment cover and secure with the screw.
CHARGING
1. Make sure the controller is turned ON.
2. Turn the ON/OFF switch on the helicopter to
OFF, and insert the charging line. The green
charging indicator on the controller will turn
on when charging and off once charged.
Charging takes about 45 minutes for 6 minutes
of fl ight time. Do not overcharge.
3. Install new batteries in the controller when
you notice fl ight times begin to decrease.
DIRECTION CONTROL - TRIM
Located on the top of the Controller is the Trim Control. When the helicopter
does not drive or fl y straight, use the Trim Control to adjust the alignment.
US9969IS01EXC.indd 3 US9969IS01EXC.indd 3

BATTERY INSTALLATION

3
7/29/11 11:32 AM 7/29/11 11:32 AM