Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for EB Excalibur Sky Patroller
Summary of Contents for EB Excalibur Sky Patroller
-
Page 1: User Guide
Sky Patroller Remote Control Helicopter User Guide SAVE THESE INSTRUCTIONS. READ COMPLETE INSTRUCTIONS BEFORE USE. #XC5380 © 2011 EB Excalibur, Inc. XC5380IS01EXC.indd 1 XC5380IS01EXC.indd 1 8/29/11 3:43 PM 8/29/11 3:43 PM XC5380IS01EXC 5 x 7 6/16/11; Revised 6/24/11; 6/27/11; 6/28/11; 7/12/11... -
Page 2: Battery Installation And Charging
ongratulations on your new EXRC purchase! EXRC pilots experience superior remote control fl ight and excellence in the look and feel of our products while commanding the skies. Now that you are a honorary EXRC pilot, we recommend reading through this manual thoroughly before attempting your fi rst fl ight. -
Page 3: Flying Your Helicopter
FLYING YOUR HELICOPTER GETTING STARTED • Select the frequency band on the controller. The frequency on the helicopter will automatically sync. • Switch the helicopter’s ON/OFF switch to the ON position. The power light will turn on. • Place the helicopter on the ground with the tail pointed toward you and the nose facing away from you. - Page 4 Flight Conditions: Please ensure the following conditions for your fl ight location: • Indoor Environment with little air conditions. Heavy air-conditioning can be too strong of conditions for heli fl ight. It is also highly recommended to turn off all electric fans, air conditioning units, or reading lamps that could impair fl ying.
-
Page 5: Troubleshooting
Troubleshooting: Problem Cause Correction Gently press forward on the left joystick and Helicopter is not Channel selection on responding to remote the remote. switch between all 3 channels until the helicopter takes fl ight. Avoid all other remote controlled devices running Interference of another on the same channel. - Page 6 FCC Part 15 Compliance The device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifi cations not expressly approved by the party responsible for compliance could void the user’s authority to operate the product.
- Page 7 XC5380IS01EXC.indd 7 XC5380IS01EXC.indd 7 8/29/11 3:43 PM 8/29/11 3:43 PM...
- Page 8 WARNING CHOKING HAZARD - Small Parts. Not for children under 3 years. EB Excalibur, Inc., Miami, Florida www.EBExcalibur.com service@ebexcalibur.com Distributed in the United Kingdom by: EB Brands UK, Worcester WR4 9FA Actual product may diff er slightly from photograph. XC5380IS01EXC XC5380IS01EXC.indd 8...
Need help?
Do you have a question about the Sky Patroller and is the answer not in the manual?
Questions and answers
The helicopters (2) will not charge. I have put in BRAND new batteries and the green light never comes on. I have followed the instructions for charging. I have left them charged for 24 hours and no charge. The controller light blinks red.
If the EB Excalibur Sky Patroller helicopter will not charge despite using new batteries and following the instructions, possible reasons include:
1. Weak Battery Power – The helicopter battery may be too weak to hold a charge. Try recharging it again.
2. Non-Rechargeable Battery – The manual states that the pre-installed battery is non-replaceable. If it has reached the end of its lifespan, it may no longer charge.
3. Battery Type Issues – Ensure you are not mixing different types of batteries (alkaline, carbon-zinc, or nickel-cadmium) in the remote.
4. Exhausted Batteries – If the batteries in the remote are old, replace them with fresh ones.
5. Charging Process – Verify that the charging procedure is being followed correctly, as improper connections or methods could prevent charging.
If none of these solutions work, the battery or charging system may be faulty.
This answer is automatically generated
When charging for 1st time red light keeps blinking.