Congratulations on your new EXRC purchase! EXRC pilots experience superior ight and excellence in the look and feel of our products while commanding the skies. Now that you are a honorary EXRC pilot, we recommend reading through this manual thoroughly before attempting ight tips, safety precautions, and care instructions to keep your EXRC helicopter in tip-top shape for ight missions.
ACTIVATING GLOW IN THE DARK FEATURE Energize the Night Raider’s glow in the dark body by using a bright light source (e.g. next to the window on a sunny day or under a table lamp) for 10 minutes. Please be sure that the helicopter is turned o . Caution: Do not leave the Night Raider unattended under direct sunlight for a prolonged period of time.
FLYING YOUR HELICOPTER Band Selector GETTING STARTED Band Selection 1. Select the frequency band on the controller. (A, B or C) 2. Move the chopper’s switch to the ON position. The helicopter will light up, indicating it is on. 3. Carefully hold the chopper in one hand, be sure the blades are clear of any obstacles.
TRIMMING HELICOPTER/DIRECTION CONTROL Virtually no trimming is required for the Night Raider. However, if the helicopter ight, use the Rudder Trim Knob on the top right side to adjust. 1. When the helicopter is spinning clockwise, turn the Rudder Trim Knob counterclockwise to adjust.
SAFETY TIPS • Read through the entire instruction manual, before attempting to pilot your helicopter. • This product is intended for indoor use, and works best indoors. We do not recommend using the product outdoors. y your helicopter in a cluttered space. This helicopter was intended for obstacle free wide area spaces.
TROUBLESHOOTING (continued) Problem Cause Correction Loss of Control Interference of another Avoid all other remote controlled devices running on the same channel. remote controlled device Change environment to better suited conditions. Interference by other conditions such as lighting. Helicopter Spinning out Incorrect trim nd the proper adjustment.
Page 8
FCC Part 15 Compliance cations not expressly approved by the party responsible for compliance could void the user’s authority to operate the product. NOTE: This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.