zapco ZX-series Owner's Manual page 8

ZX-26KD
GND
GROUND
GND
GROUND
To +12V DC
+12V Power
Connect the +12V terminal of the amplifier to the + terminal of the battery using the same diameters
the power and ground cables, making sure you install in-line fuse holders, approximately 12" from
the + terminal of battery, making sure that there is no fuse in the battery holder.
GROUND
Disconnect the battery and connect the GND (ground) terminal to the cars chassis.
Keep this cable as short as possible (not longer than 500 mm. or less).
This connection MUST be made at the frame and be rust free and clear of paint or grime.
REMOTE
Connect the REM terminal of the amplifier to the =12 Trigger out of the source unit, or an accessory
terminal at the fuse box or ignition switch.
First make the ground connection, then +12V wire connection, and finally the remote
connection. Furthermore, the +12V wire must always be fused at the battery for protection
against possible damage. If you need to replace the power fuse, replace it with a fuse of
the same value. It may result in a serious hazard to use a fuse of a different type or rating.
POWER CONNECTION
B+ B+ REM
POWER INPUT B POWER INPUT A
B+ B+ REM
POWER INPUT E POWER INPUT D
to REMOTE Turn-on
from HEAD UNIT
To +12V DC
BATTERY
GROUND
Caution
-4-
GND B+ GND
POWER INPUT C
GND B+ GND
POWER INPUT F
GROUND
HEAD UNIT
Recommended Ampere
250A x 6 (External Type Fuse)
GROUND
GROUND
GROUND
To +12V DC