zapco ZX-series Owner's Manual page 12

ZX-6.5KD / 10KD
Dual Amplifier Speaker Connection
"MASTER UNIT"
SPEAKER OUTPUTS
"SLAVE UNIT"
SPEAKER OUTPUTS
Using a dual amplifier configuration, the MASTER amplifier has total control over the SLAVE
amplifier. The positive terminal of the subwoofer's voice coil must be connected to the
positive terminal of the MASTER Amplifier and the negative terminal of the subwoofer's
voice coil must be connected to positive terminal of the SLAVE Amplifier. Since the dual
amplifier configuration has tremendous output potential, please ensure that your subwoofers
can handle such a large amount of power.
When utilizing the dual amplifier configuration, it is important to note that the
connected speakers' load cannot be lower than 2 ohms. Connecting a lower
impedance load can damage the amplifier and void your warranty.
SPEAKER CONNECTION
SUB BASS BASS
REMOTE
GAIN SONIC BOOST FREQ.
10V 0.2V 10Hz 70Hz 0dB 12dB 30Hz
INPUT OUTPUT
CH1 CH2 CH1
Use 8 Gauge(AWG) wire cable
SUB BASS BASS
REMOTE
GAIN SONIC BOOST FREQ.
10V 0.2V 10Hz 70Hz 0dB 12dB 30Hz
INPUT OUTPUT
CH1 CH2 CH1
Caution
-8-
PHASE
LPF SHIFT
90Hz 30Hz 250Hz 0 180
SLAVE
MASTER SLAVE
MASTER
OUTPUT INPUT
CH2
DAISY-CHAIN
PHASE
LPF SHIFT
90Hz 30Hz 250Hz 0 180
SLAVE
MASTER SLAVE
MASTER
OUTPUT INPUT
CH2
DAISY-CHAIN
PWR
PRT
2~8 ohms
PWR
PRT