Omron E5EN User Manual page 94

Direct/reverse operation
Direct operation" refers to control where the manipulated variable is increased
according to the increase in the process value. Alternatively, reverse operation"
refers to control where the manipulated variable is increased according to the
Function
decrease in the process value.
: Reverse operation/
Comment
Alarm 1 type
Select one of the following alarm 1 types:
Deviation/Deviation range/Absolute value
Function
Refer to the alarm 2, 3 type list on the following page.
Comment
F
Related parameters
Alarm value 1" (operation level) (p. 5 7)
Upper limit alarm value 1" Lower limit alarm value 1" (operation level) (p. 5 8)
See
Standby sequence reset method" (p. 5 31) Alarm 1 open in alarm" Alarm 1 hyster
esis" (p. 5 32) (advanced function setting level)
Alarm 2 type
Alarm 3 type
Select one of the following alarm 2, 3 types:
Deviation/Deviation range/Absolute value
Function
Setting Range
: Direct operation
The alarm 1 type must be supported.
The alarm 2, 3 type must be supported.
The control must be set to standard control.
Initial Setting Level
Default
5-25