Appliance Preparation; Top Vent - Heatilator NDV3630 Owner's Manual Installation And Operation

9 9

Appliance Preparation

A. Top Vent
CAUTION! Risk of Cuts/Abrasions/Flying Debris. Wear
protective gloves and safety glasses during installation.
Sheet metal edges are sharp.
NOTICE: Once appliance is set up for top or rear venting,
it CANNOT be changed at a later time.

Figure 9.1
• Remove the cover plate by removing the two screws
holding it to the top of the appliance. Remove and discard
the cover plate.
Figure 9.2
• Remove the center insulation plug.
Figure 9.3
• Cut the metal retaining band and fold the sides out.
Heatilator • Novus NDV Series • 4055-187 Rev. AA • 10/13
Figure 9.4
• Fold the center parts of the retaining band up and use
to remove the vent cap.
Figure 9.5
• Discard the vent cap, remove and discard the insulation
basket. Note: Once the vent cap has been removed it
cannot be reattached.
Figure 9.6
• Attach the fi rst vent section. It will snap into place.
Proceed to Section 9.C.
37