Pentair QuickStat-TC Installation And Operation Manual page 5

Vacation Mode
In this mode, the QuickStat-TC is set to the Vacation setpoint
temperature and will override all programming until Vacation
mode is disabled. To place the QuickStat-TC in this mode:
1. Press the button, and the
2. To disable Vacation mode, press the Mode/Ret button to
change the mode to Automatic
To reset the QuickStat-TC to factory default settings:
3. Turn the thermostat to Off.
4. Press the up button and switch the thermostat On.
5. After the thermostat setup is completed, release the up
button .
Error Message
The measured temperature is below the thermostat's
display range. Heating is activated.
The measured temperature is above the thermostat's
display range. Heating is deactivated.
Verify the floor sensor connection to the thermostat.
THERMAL MANAGEMENT SOLUTIONS
icon appears on the display.
or Manual .
ML-RaychemQuickStatTCthermostat-IM-H58517 01/13 5 / 6