Set-Up; Connecting The Printer Cable; Installing The Software - Oce OP30C Operation Manual

2. Set-up

2-1

Connecting the printer cable

CAUTION: ALWAYS turn the main switch to the printer OFF (O)
BEFORE connecting the printer cable.
1 Turn the main switch located on the left side of the printer
OFF (O). If you are connecting the printer to your computer
with a parallel or serial cable, turn the power off to your
computer as well.
2
Connect the printer cable to the interface connector located
at the back of the right side of the printer.
The following types of interface come standard with the
printer. Be sure to connect the printer cable to the interface
connector that is appropriate to your situation.
A Parallel interface connector
B Serial interface connector
C Network interface connector (100BASE-TX or 10BASE-T)
* If you are going to use this machine as a network printer,
perform the appropriate network settings. (Refer to "2-3
Network (TCP/IP) settings" on page 5.)
4
A
B
C
3 If you are connecting the printer to your computer with a
parallel or serial cable, connect the other end of the printer
cable to the connector on your computer.
If you are connecting the printer to a network, connect the
other end of the printer cable to an appropriate hub.
4
Turn the main switch to the printer back ON ( | ).
2-2

Installing the software

Perform the following procedure to install into your computer the
printer driver and other software that is appropriate to the operating
system in use in that computer. For information on installing the
required software, refer to the On-Line Manual that is located on the
CD-ROM that is included with this product.