Table of Contents
Advertisement
Instructions For Use
·
The heater can be operated either by the switches located on the top right hand side of the fire place or
by supplied remote control.
Manual Operation
·
The switches are located at the top, right hand side of the heater.
·
The standby switch must be switched on first, and foremost.
·
Press O/I button once to turn on the heat and fire effect. The LED lights will light up to indicate that it is ON.
· Press the 750W button once for the low heat settings; press twice to switch off this heat setting.
· Press the 1500W button once for the high heat settings; press twice to switch off this heat setting.
Remote Operation
·
For proper remote operation, the standby switch located at the top right hand side of the heater must first be
MANUALLY switched ON.
· It takes a little time for the receiver to respond to the transmitter. Be patient. DO NOT press the buttons more than one
time within two seconds to avoid cross signals.
· Press the ON/OFF button once the remote control to turn the heat and fire effect on or off.
· Press the 750W button once for the low heat settings; press twice to switch this heat setting off.
· Press the 1500W button once for the high heat settings; press twice to switch this heat setting off.
Safety Cut-Off
· This heater is equipped with an overheat safety cut-off switch that will engage if the heater overheats for any reason.
·
For safety reasons, the heater will NOT automatically reset after the safety cut-off switch has engaged.
· To reset it, disconnect the heater from the main power outlet for at least 15 minutes.
·
You can then reconnect it to the power outlet and switch it back on.
Maintenance
WARNING: ALWAYS UNPLUG THE CORD BEFORE MOVING OR SERVICING.
DO NOT IMMERSE HEATER IN WATER!
Always turn OFF the heater and disconnect the cord from the electrical outlet before cleaning your heater.
Light accumulated dust may be removed from the heater with a soft cloth or vacuum cleaner.
Wipe the exterior surfaces of the heater occasionally with a slightly damp cloth (not dripping wet) using a solution of mild
detergent and water. Dry the case thoroughly before operating the heater.
Caution: Do not allow water to run into the interior of the heater as this could create a fire or electric shock hazard.
The fan motor is factory lubricated for life and will not require further lubrication.
Store the heater in a clean dry place when not in use.
Warning: Any other servicing needed must be performed by an authorized service representative. Do not attempt to
service the unit yourself.
After Season Care:
Store the heater in a cool, dry location.
The manufacturer recommends storing the unit in its original carton.
Troubleshooting
Problem
No operation/ no fan.
No fire effect light.
Solution
Check for safety cut-off operation.
Check the bulb by replacement.
Advertisement
Table of Contents
