Time And Status Display - Kenmore 796. 8147 Series Use & Care Manual

TIME AND STATUS DISPLAY

The Time and Status Display shows the cycle time, cycle
progress, and vent status. When the dryer is turned on, the
display will illuminate.
D
A
TIME DISPLAY
When a cycle is selected, the display will indicate
the default time for that cycle including selected
options or adjustments. In AUTO DRY cycles, the
time remaining will be estimated and may change
during the cycle, depending on the condition of the
load. In TIMED DRY, the time displayed will be the
actual time remaining.
B
CHECK FILTER LIGHT
The CHECK FILTER light will blink before each load,
as a reminder to check the lint filter. Always clean
the lint filter before every cycle.
C
CYCLE STATUS INDICATORS
This portion of the display shows which stage of the
drying cycle is currently under way (DRY, COOLING,
or WRINKLE GUARD).
B
C
F
D
CHECK VENT INDICATOR
(DUCT BLOCKAGE SENSING SYSTEM)
The CHECK VENT duct blockage sensing system
detects and alerts you to blockages in the ductwork
that reduce exhaust flow from the dryer. This light
does not indicate any problems with your dryer. If
this light blinks, it indicates that your home's exhaust
system has a serious restriction, which is not covered
by your dryer's warranty. Call 1-800-4-MY-HOME
for information regarding duct cleaning services
offered through Sears.
E
CONTROL LOCK
When CONTROL LOCK is set, all controls are
disabled which will allow the dryer to be shut off.
When the controls are locked, the dryer can not be
operated until the CONTROL LOCK is turned off. If
the controls are locked, the CONTROL LOCK LED
will illuminate and "CL" will alternate with the cycle
time in the display.
ADD WATER INDICATOR
F
If the steam feeder runs low on water, the ADD
WATER light will blink and the cycle will cancel.
Refill the steam feeder and then restart the cycle.
23
E
A
HOW TO USE
®