Table of Contents
Advertisement
Attaching the speakers to the unit
Connect the wires to the unit.
To connect the cable to the unit, press each plastic
fi nger pad to open the connection terminal. The
connector will open ready to receive a cable. Insert
the wire and release the fi nger pad.
Connect the red end of each wire to the terminals marked
+(plus) and the black end to the terminals marked - (minus).
Right speaker
¤ CAUTION
Be sure to adhere to the following, or proper
ventilation will be blocked causing damage or
fi re hazard.
• Do not place any objects impairing heat radiation onto
the top of the unit.
• Leave some space around the unit (from the largest
outside dimension including projection) equal to or
greater than, shown below.
Top panel : 50 cm Back panel : 10 cm
Remote control Battery Installation
Detach the battery cover on the rear of the remote
control, and insert two R03 (size AAA) batteries with
+ and - aligned correctly. Do not mix old and
new batteries. Never mix diff erent types of batteries
(standard, alkaline, etc.).
1
Remove the cover.
2
Insert batteries.
3
Close the cover.
¤ CAUTION
Do not leave the battery near fi re or under direct sunlight.
A fi re, explosion or excessive heat generation may result.
Remote control Operation
Point the remote control at the remote sensor and
press the buttons.
Left speaker
Remote sensor
Approx. 6 m
30°
30°
English
7
|
Advertisement
Table of Contents
