Table of Contents
Advertisement
94
Configuring the NVR
In order to access the NVR remotely, the NVR Server must be setup to allow remote connections.
Time Out Value
Center Port
Image Port
Search Port
Configuring the Server for Remote Connection
1.
Enter Setup on the NVR.
2.
Click the Network Setup Button to open the Network Menu.
3.
Uncheck the Disable Remote Control option. You should now be allowed to adjust port settings if necessary.
NOTE:
If you are using a Firewall, it may be necessary to adjust the port settings on both the NVR and the Firewall.
Contact the Network Administrator for more information.
4.
Click OK.
5.
Make sure a User account is created. Without a user account, the Administrator account must be used.
6.
The NVR server is now ready to receive incoming connections.
Access Remote Connection
1.
Open the Remote Software.
2.
Click on the icon of the server as defined previously.
3.
Enter the user name and password of an authorized remote user as defined in Network > Client Setup > User Account on the E-
Series system.
NOTE: User Name and Password are both case sensitive.
4.
Click the Connect Button.
Specifies a value (in seconds) to wait for a signal
from the Surveillix Remote Client. If a signal is not
received by that time, the connection is dropped.
Used to transfer the connection data.
Used to transfer the image data.
Used to transfer the search data.
Advertisement
Table of Contents
