Error Code Chart; Dryer Settings Chart - Frigidaire Dryer Use & Care Manual

If the dryer stops, the status lights flash and the signal beeps, an error has occured. Press PAUSE/CANCEL. Consult the Error Code Chart below or the "Avoid Service Checklist" in the Owner's
Guide for the possible cause and solution. Make correction, then select a cycle and press START. If the dryer stops, status lights flash again and the beeping continues, please contact service
for assistance.
Error Code
4 beeps
6 beeps
Towels
Estimated Cycle
Duration *** 60 minutes
Temperatures
High
Medium
Low
No Heat not recommended not recommended not recommended not recommended
Dryness Level
*
More Dry
Normal Dry
Less Dry
Damp Dry
Options
Press Saver
*
Cycle Signal
* Factory setting Available settings

ERROR CODE CHART

Error
Dryer ran too long
Push button does not function

DRYER SETTINGS CHART

These temperatures, dryness levels and options are available with the following cycles:
Normal Perm Press
50 minutes 40 minutes
* *
*
* *
** Timed Dry Cycle Only
Possible Causes
Lint filter blocked. Ventilation system clogged.
Dryer overloaded.
Push button held too long or wedged in the
control panel.
Delicate Quick
20 minutes **
*
*
* *
*** Estimated cycle duration is based on normal
dryness level and factory settings.
Solutions
Remove lint; wash lint filter to remove softener
sheet residue Clean out ventilation system.
Reduce load size.
Press buttons lightly and release. Disengage
button.
Touch Up Timed Dry
** **
recommended
* *
PN 134420600C