If the dryer stops, the status lights flash and the signal beeps, an error has occured. Press PAUSE/CANCEL. Consult the Error Code Chart below or the "Avoid Service Checklist" in the Owner's
Guide for the possible cause and solution. Make correction, then select a cycle and press START. If the dryer stops, status lights flash again and the beeping continues, please contact service
not recommended not recommended not recommended not recommended
* Factory setting
ERROR CODE CHART
Dryer ran too long
Push button does not function
DRYER SETTINGS CHART
These temperatures, dryness levels and options are available with the following cycles:
** Timed Dry Cycle Only
Lint filter blocked. Ventilation system clogged.
Push button held too long or wedged in the
*** Estimated cycle duration is based on normal
dryness level and factory settings.
Remove lint; wash lint filter to remove softener
sheet residue Clean out ventilation system.
Reduce load size.
Press buttons lightly and release. Disengage
PN 134507800 (0412)