Jack List - Yamaha MW8cx Owner's Manual

9
RETURN Control
Adjusts the level at which the signal received at the
RETURN jacks (L (MONO) and R) is sent to the STEREO
L/R bus.
If you supply a signal to the RETURN L (MONO) jack
NOTE
only, the mixer sends the same signal to both the L
and R Stereo buses.
0
POWER Indicator
This indicator lights when the mixer's power is ON.
A
Level Meter
This LED meter displays the level of the signal sent to the
STEREO OUT jacks, MONITOR jacks and the PHONES
jack. The "0" segment corresponds to the nominal output
level. The PEAK segment lights red when the output reaches
the clipping level.
B
2TR IN/USB
• 2TR IN/USB Switch
If it is set to TO STEREO (
2TR IN jacks and the USB connector are sent to the STE-
REO L/R bus. If this switch is set to TO MONITOR (
the signals are sent to the MONITOR OUT jacks, the
PHONES jack, and the level meter. The MONITOR MIX
feature becomes available when it is set to TO MONITOR
( ).
* : When overdubbing, you can adjust the levels
of the monitor playback signal and the signal being recorded
separately.

Jack List

Input and Output Jacks
MIC INPUT
LINE INPUT (stereo channels)
STEREO OUT, MONITOR, EFFECT (AUX)*
INSERT
PHONES
RETURN
LINE INPUT (monaural channels)
* These jacks will also accept connection to monaural phone connectors. If you use monaural plugs, the connection will be unbalanced.
), the signals input via the
),
Polarities
Pin 1: Ground
Pin 2: Hot (+)
Pin 3: Cold (-)
Tip: Hot (+)
Ring: Cold (-)
Sleeve: Ground
Tip: Output
Ring: Input
Sleeve: Ground
Tip: L
Ring: R
Sleeve: Ground
Tip: Hot
Sleeve: Ground
MONITOR MIX Signal Flow
2TR IN/
2TR IN/USB control
USB
Playback
signal
STEREO
bus
Recording
signal
STEREO Master control
• 2TR IN/USB control
Adjusts the level of the signal sent from the 2TR IN jacks
and USB connector to the STEREO L/R bus.
C
MONITOR/PHONES Control
Controls the level of the signal output to the PHONES jack
and the MONITOR jacks.
D
STEREO Master Control
Adjusts the signal level sent to the STEREO OUT jacks.
* Impedance Balanced
Since the hot and cold terminals of impedance bal-
anced output jacks have the same impedance, these
outputs are less affected by induced noise.
Configurations
INPUT
Ring
Sleeve
Sleeve
MW8CX/MW10C Owner's Manual
Reference
Front & Rear Panels
MONITOR/PHONES controls
MONITOR/
PHONES jacks
REC OUT/USB
OUTPUT
XLR Connector
Tip
TRS Phone Connector
Tip
Phone Connector
19