Hdk7515_Connector; Ep10 Hdk Demo Application - Psion EP10 User Manual

3.7.4.2

Hdk7515_Connector

The Hdk7515_Connector enumeration is defined as follows:
typedef enum {
Hdk7515_Connector_Docking = 6,
Hdk7515_Connector_Invalid = 0xffffffff

} Hdk7515_Connector;

3.8

EP10 HDK Demo Application

Bundled with the EP10 HDK is a demo application that can be used to test the basic functionality of an
expansion peripheral. The files for this application (including the source code) can be located in the
..\DemoApp subfolder of where you installed the HDK files.
To run the HDK demo application, copy the 7515HDK.dll and EP10HDKDemo.exe files to the file system on
your EP10 hand-held computer. The .dll file must be located in the same folder as the executable file, or in
the system folder.
Double-tap on the executable file on the EP10 to launch the demo application. The application will run
through a sequence of function calls and report the results in status windows on the EP10 display.
• Check power mode (Auto/Manual), and set to Manual if not already set. Report result.
• Report current power state (enabled/disabled).
• Toggle the power state, and report.
• Restore the power state to original value, and report.
Tap OK to proceed through the report messages, and cycle through to the end of the application.
Chapter 3: Software

EP10 HDK Demo Application

Psion EP10 HDK User Manual
27