Hardware Installation; Cabling Assembly - Vivotek FD8362 Quick Installation Manual

3

Hardware Installation

First, use the included T20 hex key wrench to loose the four screws and detach the dome cover from the
camera base. Follow the steps below to install the camera either to a ceiling or a wall.
IMPORTANT!
tion process, physical injury could occur to your co-workers.
Top View

Cabling Assembly

Connect power lines and if you have external devices such as sensors and alarms, make the connection
from the general I/O terminal block.
Top View
For Ethernet
For Power & IO Cables
Cable
Dome cover should be removed because if it should fall during the installa-
1 2 3 4 5
Power and IO cables pass through a waterproof connector. The
Ethernet cable should be routed through a rubber seal plug. All
cables are user-supplied.
EN - 5
Dome Cover Retainer
Pin Definitions
6 7 8
The max. output load from pins #7
and 8 is 400mA.
Dome Cover
1 DC 12V-
2 DC 12V+
3 AC 24V_2
4 AC 24V_1
5 DI- (GND)
6 DI+
7 DO-
8 DO+ (12V)
NOTE: