Adjusting The Lens - Vivotek FD8362 Quick Installation Manual

7

Adjusting the Lens

Based on the live image retrieved from the camera, adjust the camera lens by doing the following:
To adjust the viewing angle -- 3-axis mechanism design
1. Loosen the tilt adjustment screws and then turn the lens module up or down. Upon completion,
tighten the screw.
2. Turn the lens to adjust the image orientation.
The sophisticated 3-axis mechanism design offers very flexible, easy hardware
installation for either ceiling or wall mount.
1
8
Completion
1. Install the black cover.
2. Attach the dome cover to the camera by combining it to the retainer and aligning with the mounting
holes.
3. Secure the four dome screws with the supplied hex key wrench. Make sure all parts of the camera
are securely installed.
2
NOTE:
You will find a silica gel bag attached to the
dome cover. Replace the silica gel included in the
camera with the one shipped within the accessory bag.
2
Tilt Adjustment
Screws
1
Black
Cover
3
EN - 12
Vertical Tilt 80°
Lens Horizontal
Pan 350°
Horizontal Pan
350°
3