Eaton Powerware 3105 User Manual
350 - 700 va
Hide thumbs
Also See for Powerware 3105:
- User manual (12 pages) ,
- Reference manual (120 pages) ,
- User manual (2 pages)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Reference Manual
Advertisement
Table of Contents
Related Manuals for Eaton Powerware 3105
Summary of Contents for Eaton Powerware 3105
- Page 1 Powerware 3105 UPS User’s manual...
- Page 2 ©2005 Eaton Corporation All Rights Reserved The contents of this manual are the copyright of the publisher and may not be reproduced (even extracts) unless permission granted. Every care has been taken to ensure the accuracy of the information contained in this manual, but no liability can be accepted for any errors or omission.The right...
-
Page 3: Table Of Contents
Powerware 3105 UPS User’s manual 1023921 Revision A Contents Introduction....................4 Features ........................4 Unit inspection......................4 Requesting a Declaration of Conformity ............... 4 Safety Instructions ..................5 Battery connection required before use!.............6 Connecting the Battery:................... 6 Installation and Operation:................6 Typical applications ....................7 Indicators ....................7... -
Page 4: Introduction
Compact design fits on/under your desk; can also be mounted to a wall Unit inspection Once you have received the Powerware 3105 UPS product, you should remove and inspect the product for shipping damage. If any damage is found, please notify the carrier and your dealer. -
Page 5: Safety Instructions
” 1. Place the Powerware 3105 UPS indoors in an area that has adequate airflow and is free of excessive dust. Do NOT allow the UPS to be exposed to moisture, rain, excessive heat, or direct sunlight. -
Page 6: Battery Connection Required Before Use
Principal shown below for detailed information how to connect please refer to battery replacement section. Installation and Operation: Following steps explain how to connect and operate the Powerware 3105 UPS. 1. Connect the UPS to a grounded power outlet. Note It is recommended that the battery should be charged for minimum 8 hours to ensure full charge before placing the UPS in service. -
Page 7: Typical Applications
Typical applications Indicators 1. On/Off Push Button/Test Switch One switch controls the power to your equipment. Upon power turn on, unit performs a self-test to detect overload or undercharged conditions. Turn on the UPS Press and hold the push button switch depressed for more than one second. Release the switch after the audible beep is sounded. -
Page 8: Battery Replacement Procedure
2. On/Off Battery LED Indicates the UPS is on and is powering your equipment. A constantly illuminated LED indicates normal utility power operation. A blinking LED indicates that the UPS is providing power from its battery. 3. Fault/Warning LED Indicates a fault or warning condition is present. A constantly illuminated LED indicates a LOW battery condition. -
Page 9: Status Indicators
350VA and 500VA models (12V-4.5Ah,or 5Ah battery) 700VA model (12V- 7Ah battery) Status Indicators The UPS provides both visual and audible status indicators. Visual indicators consist of three LEDs to represent the following conditions: • On utility power operation • On battery power operation •... -
Page 10: Led And Alarm Statustable
LED & Alarm Status Table UPS status Green LED Red LED Buzzer Self test Blink 1 (by turns) Charging Charge off AC (Utility mode Low battery Blink 2 Over load Blink 2 Normal Blink 2 DC (Battery Over load Blink 2 Mode) Low battery Blink 2... -
Page 11: Troubleshooting
Troubleshooting Symptom Possible Cause Action to Take The battery is disconnected Connect the battery (see Connect Battery) and utility power is not and ensure power is available at the wall available at the wall outlet. outlet. UPS will not turn on. Reduce the amount of equipment plugged into Input Circuit Breaker has the outlets of the UPS.
Need help?
Do you have a question about the Powerware 3105 and is the answer not in the manual?
Questions and answers