Mazda Tribute (j14) Owner's Manual page 40

Lights
Replacing front parking/turn signal lamp bulbs
1. Make sure that the headlamp control is in the OFF position.
2. Open the hood. The position lamps are located on the bottom half of
each headlamp.
3. Disconnect the electrical connector from the bulb by pulling
rearward.
4. Remove the bulb socket from the lamp assembly by turning
counterclockwise.
5. Pull the bulb straight out of the
socket and push in the new
bulb.
6. To complete installation, follow
the removal procedure in
reverse order.
Replacing fog lamp bulbs (if equipped)
WARNING: Handle a halogen
bulb carefully and keep out of
children's reach. Grasp the
bulb only by its plastic base
and do not touch the glass.
The oil from your hands could
cause the bulb to break the
next time the headlamps are
operated. Always wear safety
glasses when handling halogen
bulbs.
1. Remove the bulb socket from the fog lamp by turning
counterclockwise.
2. Disconnect the electrical connector from the fog lamp bulb.
3. Connect the electrical connector to the new fog lamp bulb.
4. Install the bulb socket in the fog lamp turning clockwise.
NOTE: If the bulb is accidentally touched, it should be cleaned with
rubbing alcohol before being used.
40
2005 Mazda Tribute (j14)
Owners Guide (post-2002-fmt)
USA English (fus)