Daikin FT18HEV1K Operation Manual And Installation Manual page 12

Remote control operation
Lock
Press + and – buttons simultaneously to lock or unlock the keyboard. If the remote control is
locked, is shown. Press any button and the symbol will flicker three times. The symbol
disappears when the keyboard is unlocked.
Swing Up/Down
1. Pressing the swing up and down button for more than 2 seconds starts the main unit
swing up and down function. Release the button to stop the guide louver at the desired
position.
2. In Swing mode when the status is changed from off to
2 seconds later
position of the swing.
Fahrenheit/Celsius
When the unit is off, press MODE and "–" buttons simultaneously to switch between °C and °F.
Defrost mode
If the unit has been in defrost and is turned off with the remote controller, the unit will not stop
until defrosting is complete. Additionally, settings made with the remote controller will not be
carried out until defrosting is complete.
Switching this function on/off: If the remote control is off, press the mode and blow buttons
simultaneously to enter or cancel this function. If the unit is in defrost mode, the dual eight
position on the remote controller displays H1. When changing to heat mode, H1 is displayed
and flickers for 5 seconds. Press +/– button to display the temperature setting. When turned
on next, the default defrost mode will be set to close.
(1) Push lightly on the symbol in the direction of the arrow and open
the battery compartment.
(2) Remove the old batteries.
(3) Insert two new AAA1.5V dry batteries with the polarity in the
correct position.
(4) Attach the back cover of the remote controller.
NOTE:
• Do not use old or unspecified batteries.
Doing so can cause the remote controller to malfunction.
• Remove the batteries from the remote controller when it is not in
regular use.
• Use the remote controller within receiving range of the AC.
• Keep the remote controller approximately 1m away from TV or
stereo equipment.
• If the remote controller does not operate correctly, remove the
batteries, wait 30 seconds, and reinsert them. Replace the
batteries if this does not help.
status will change to off. The swing status change depends on the
Battery replacement
, if you press this button again
(2)
(3)
How to replace
batteries
(1)
(4)
11