Qlink XF200 User Manual page 35

Headlamp
1. Loosen three screws and pull out the lamp assembly.
2. Disconnect cable connector, put off rubber and put out bulb.
3. Install a new bulb and replace the assembly.
Precaution:
The lamp assembly is of reflection type. Do not touch the reflection lens in bulb
replacement to avoid reducing its service life.
Turning signal lamp
1.Remove two screws and take off the lamp lens.
2.Press the bulb and turn it leftward to take it out.
3.To install a new bulb, press it down and turn it rightward.
Precaution:
After installing the lamp lens, be careful not to over tighten the screws to avoid
damaging the lamp lens.
Tail/Brake Lamp
1. Remove the lamp cover by loosening the two screws.
2. Screw out the bulb by pressing and turning it to the left.
3. Renew a bulb.
USER'S MANUAL USER'S MANUAL
3 32