EnGenius ENH500 User Manual page 50

IP Address
IP Subnet Mask
Gateway IP Address
PPTP Server
Username
Password
Connect on Demand
Keep Alive
Get Automatically
From ISP
Use These DNS Servers Select the Radio button for setup the Primary DNS and
Discard Ping on WAN
Accept / Cancel
Accept does not compile the changes, you must go to Status -> Save/Load to apply the new
settings. Please refer to the chapter 4.1 for more detail.
If the router's MTU is set too high, packets will be fragmented downstream. If the router's
MTU is set too low, the router will fragment packets unnecessarily and in extreme cases may
be unable to establish some connections. In either case, network performance can suffer.
Specify WAN port IP address.
Specify WAN IP Subnet Mask.
Specify WAN Gateway IP address.
Specify PPTP Server IP address.
Specify the Username that is given by your ISP.
Specify the Password that is given by your ISP.
Select the Radio button to specify the maximum idle time.
Internet connection will disconnect when it reach the maximum
idle time, but it will automatically connect when user tries to
access the network.
Select the Radio button to keep internet connection always on.
Specify the redial period once the internet lose connection.
Select the Radio button for get the DNS automatically from DHCP
server.
Secondary DNS servers manually.
Place a Check to Enable or Disable ping from WAN.
Press Accept to confirm the changes or Cancel to return previous
settings.