Control Panel Operation; Configuration (Dmx); Starting Address - Chauvet Scorpion Storm RGB EU User Manual

4. O
PERATION



To access the control panel functions, use the four buttons located underneath the
Control Panel
display. When the product is on, the LED monitor on the rear panel will show the current
Operation
operating mode (standalone or DMX). The product will retain the last saved settings when
powered off.
Menu Map
Configuration
(DMX)

Starting Address

Scorpion Storm RGB EU User Manual (Rev. 2 ML)
This product is not designed for continual use. Make sure there are regular
breaks during operation to maximize the life of your laser.
Always disconnect the Scorpion™ Storm RGB EU from power when not in use.
A Laser Safety Scanner Board is built-in. Laser light will automatically be turned
off when the scanned angle is less than 2°.
Button
Selects an operation mode or to backs out of the current menu option
<FUNC>
Scrolls up the list of options or selects a higher value
<UP>
Scrolls down the list of options or selects a lower value
<DOWN>
Activates a menu option or a selected value
<ENTER>
Mode Programming Steps
DMX
Slave
Sound-Active
Automatic
Remote
Set the product in DMX mode to control with a DMX controller.
1. Connect the product to a suitable power outlet.
2. Turn the product on.
3. Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket on the product.
Once the DMX cable is connected with the laser and the DMX controller, the DMX
indicator LED on the front panel will be On.
When selecting a starting DMX address, always consider the number of DMX channels
the selected DMX mode uses. If you choose a starting address that is too high, you could
restrict the access to some of the product's channels.
The Scorpion™ Storm RBG EU uses up to 6 DMX channels in its DMX mode, which
defines the highest configurable address to 507.
If you are unfamiliar with DMX, download the DMX Primer from www.chauvetlighting.com.
To select the starting address, do the following:
1. Press <FUNC> repeatedly until 001 shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select the starting address.
4. Press <ENTER>.
Function
Description
Selects the DMX starting address
001~512
The slave product follows the actions of
SLA
the master product
The internal program runs to the beat of
Sou
the music (fast or slow)
Automatic fast/slow; automatic sound-
Aut
sensitive mode fast/slow
Sets the product to operate with the
rEn
remote controller
9