Intellitouch I-Link Adapter Software Commands; Start Up Sequence - Pentair i-Link User Manual

1
Overview
This manual provides IntelliTouch
IntelliTouch system equipment such as lights, pumps etc. For additional
information about the IntelliTouch control system, refer to the IntelliTouch User's
Guide (P/N 520102).
IntelliTouch i-Link Adapter
Start-up Sequence
Each time the IntelliTouch i-Link adapter is powered up a start-up initialization
sequence is sent to the Home Automation system via the RS-232 port and the
current command characters display. These special command characters are also
user definable and may differ from the default characters show below. The
default command character set displays after a start-up sequence. To display these
characters power down/up or reset the IntelliTouch i-Link adapter. For the RST (reset)
command information, see page 4.
IntelliTouch i-Link Adapter Default Command Characters
Pentair Water Pool and Spa - IntelliTouch i-Link Protocol InterfaceAdapter v1.0
CMDCHR = #
NRMCHR = !
ERRCHR = ?
SETCHR = =
INQCHR = ?
Acquiring System Data
!READY
The IntelliTouch system implements an addressing method upon power
up. For most systems the initialization is automatic. The IntelliTouch i-Link
adapter will automatically lock on to the address within two minutes after
power is applied.
Note: If there is an IntelliTouch MobileTouch
the MobileTouch Transceiver screw terminal connector needs to be removed
from the Transceiver circuit board before the IntelliTouch i-Link adapter
initialization sequence. Refer to Start-up with MobileTouch Control Panel, see
page 25 for details.
IntelliTouch i-Link Protocol Interface Adapter User's Guide
® ™
i-Link software control commands for
Software Commands
® wireless control panel installed,