Cleanr: Cleaner Control - Pentair i-Link User Manual

9
CLEANR:
Request State:
Query:
Response:
Set State:
Command:
Response:
Toggle State:
Toggle:
Response:
Note: The CLEANR commands assume a circuit has been configured as a
cleaner. If there are no circuits configured, the response will be an error
message.
?23 OPTION SWITCH NOT SET
IntelliTouch i-Link Protocol Interface Adapter User's Guide
Cleaner Control
Control/Query/Toggle Cleaner.
#CLEANR ?<cr>
!00 CLEANR = x<cr>
!00 x<cr>
Where x is 1 or 0, and 1 indicates ON, 0 indicates OFF
#CLEANR = x<cr>
Where x is 1 or 0, and 1 indicates ON, 0 indicates OFF
!00 CLEANR = x<cr>(RSPFMT = 0)
!00 x<cr>
Where x is 1 or 0, and 1 indicates ON, 0 indicates OFF
#CLEANR <cr>
!00 CLEANR = x<cr>
!00 x<cr>
Where x is 1 or 0, and 1 indicates ON, 0 indicates OFF
(RSPFMT = 0)
(RSPFMT = 1)
(RSPFMT = 1)
(RSPFMT = 0)
(RSPFMT = 1)