Trane AQUASTYLUS CFEA 04 C0M1 Owner's Manual page 7

UNT-SVU001-EN
AW 02092023TRA
Black
Wireless Remote Control
Setting Clock
To set clock, press CLOCK button
until CLOCK symbol
The current time value can be set by
pressing HOUR or MIN (minute)
button.
Note : During the clock symbol is
blinking (the time valve has not been
changed), if there are no other buttons
pressed within 10 seconds, the LCD
display will return to show setting
temperature when the handset is
under POWER ON status, or to show
current time value when the handset
is under POWER OFF status.
Timer Operation
Once you select the timer operation,
the settings are saved in the remote
control. Thereafter, the air conditioner
will start operating under the same
conditions when you simply push the
POWER button of the remote control.
Setting STOP Timer
You can set the STOP timer to stop
the unit automatically at any desired
time up to 24 hour ahead.
- Press STOP button to set time to
turn the unit OFF. The OFF symbol
is starting to blink.
- Press HOUR or MIN buttons to
change the time (pass this step, if
no time change is required).
At this stage, if there are no other
buttons pressed within 10 seconds,
the LCD display will return to show
setting temperature or current time
valve. No setting is changed.
- Press SEND or STOP buttons
to transmit the signal to the air
conditioner. The set time will stop
blinking.
- The unit will stop automatically at
set time of OFF timer.
- To cancel the STOP timer, press
STOP button again.
7
Setting START Timer
You can set the START timer to start
is blinking. the unit automatically at any desired
time up to 24 hour ahead.
- Press START button to set time to
turn the unit ON, the ON symbol is
starting to blink.
- Press HOUR or MIN buttons to
change the time (pass this step, if
no time change is required).
At this stage, if there are no other
buttons pressed within 10 seconds,
the LCD display will return to show
setting temperature or current time
valve. No setting is changed.
- Press SEND or START buttons to
transmit the signal to the air
conditioner. The set time will stop
blinking.
- The unit is now standby for starting
automatically at set time of START
timer.
- To cancel the START timer,
press START button again.
Note : In case of power failure,
the START/STOP timer will be
automatically cancelled as there is
no electricity in the air-conditioner.
(But the set time on the remote unit
is still displayed due to the batteries).
If any button or the remote unit is
pressed when the electricity is back
to normal, this feature will be
re-activated.
29/10/02, 2:51 PM
7