Belkin N600 DUAL-BAND User Manual page 20

ADVANCED SETTINGS
Wi-Fi Protected Setup
Your Dual-Band Wi-Fi Range Extender supports the Wi-Fi
Protected Setup™ (WPS) specification, which simplifies the setup
of a wireless network. WPS uses familiar methodologies, such as
typing in a Personal Identification Number (PIN) or pushing a
button, to enable users to automatically configure network names
and strong WPA/WPA2 data encryption and authentication.
Using Wi-Fi Protected Setup™
Belkin recommends that you set up WPA2 as your wireless security.
WPS does not provide additional security, but rather simplifies
the addition of wireless devices to your wireless network. You
may use either the Push Button Configuration (PBC) method or
PIN method to allow a device access to your wireless network.
PBC: Push and hold the WPS button located on the front of your
Range Extender for two seconds and the security LED will flash,
indicating that WPS has been initiated. Then, initiate WPS on the client
device within two minutes (refer to your client's documentation on this
procedure). The wireless device and Range Extender will automatically
exchange a security key and establish a secure connection.
PIN: The client device has a WPS PIN number (eight digits) that
will be provided to you when you initiate the connection to the
Range Extender. Enable WPS through the screen illustrated to the
below. Enter the client's PIN into the Range Extender's internal
registrar (accessed through this screen). The client will be securely
enrolled into your wireless network within two minutes.
Cross-Band
Cross-band is a Belkin wireless feature that allows your range
extender to use both Wi-Fi bands to deliver faster speeds in your
network. The feature is automatically enabled when your range
extender is connected to a dual-band router. If your range extender
connects to a single-band router, this feature will be disabled. If
you wish to disable Cross-band manually and still connect to a
dual-band network, type: http:// belkin.range/crossband.asp in
a web browser and uncheck the "Cross-Band Enabled" box.
Dual-Band Wireless Range Extender
Wi-Fi Protected Setup (WPS)
Status
2.4Ghz Wireless Connection
5Ghz Wireless Connection Wi-Fi Protected Setup
Extended Networks Settings
SSID Settings
WPS Hardware Button
Security
Wi-Fi Protected Setup (WPS)
Utilities
Restart Extender
1) Personal Identification Number (PIN) Method
Restore Factory Defaults
Enter the PIN from the client device and click "Enroll". Then start WPS on the client device from it's
wireless utility or WPS application within 2 minutes
Firmware Update
Administrator Password Enter Client Device PIN
Log
2) Push Button Configuration Method
Push and hold PBC button on the Extender for 3 seconds or click "Start PBC". Then start PBC on the
device you want to connect to the Router within 2 minutes.
18
Enabled - 2.4 Ghz
more Info
Enabled
Apply Changes
Enroll
Start PBC