Putting On The Heart Rate Monitor - Mio Cyclo series User Manual

3. When done, you can manually pair the sensor with your device by tapping
Main menu > Settings > Sensors > Cadence/Speed Rescan.
Information:
The cadence sensor contains a replaceable CR2032 battery. Follow the instructions
below to replace the battery:
1. Locate the battery cover on the back of the sensor, and then twist the cover
anticlockwise (e.g. by using a coin) to remove the cover and battery.
2. Insert the new battery into the battery chamber and replace the cover.
3. Twist the cover clockwise (e.g. by using a coin) to close the cover.
1
2
c

Putting on the heart rate monitor

The heart rate monitor is used for selected models only.
1. Before using the heart rate monitor, wet the contacts on the back of the
chest strap.
2
3
b
Tip: If possible, you can also use an electrolyte gel (usually available in local running
store) to ensure good contact.
3
a
d
4
2. Adjust the elastic strap so it's snug while you are putting it on. Ensure that
you can take a good deep breath after putting on the strap.
3. Follow the instructions below to wrap the strap around your back, and then
secure it on the other side with the buckle.
Tip: Putting on the heart rate monitor is like wearing a belt around your lower chest.
3
4. When done, you can manually pair the monitor with your device by tapping
Main menu > Settings > Sensors > Heart rate Rescan.
Information:
The heart rate monitor contains a replaceable CR2032 battery. Follow the instructions
below to replace the battery:
1. Locate the battery cover on the back of the monitor, and then twist the cover
anticlockwise (e.g. by using a coin) to remove the cover and battery.
2. Insert the new battery into the battery chamber and replace the cover.
3. Twist the cover clockwise (e.g. by using a coin) to close the cover.
1
7
2
4
2