Tripp Lite B140-101 Owner's Manual page 15

1
2
3
4
5
6
7
8
201110026-93-3094-EN.indd 15
Standard Extender/Splitter Installation
Make sure the DVI source is powered OFF.
Connect the DVI source to the DVI port on the B140-002 or
B140-004 labeled INPUT using a Tripp Lite P561-Series DVI-D
Single-Link Cable.
Optional for B140-004: Connect a DVI monitor to the DVI port on
the B140-004 marked LOCAL using a Tripp Lite P561-Series DVI-D
Single-Link Cable.
Connect the external power supply to the B140-002 or B140-004
local unit and plug it into a Tripp Lite Surge Suppressor, PDU or
UPS. The Green RJ45 LEDs and Red Power LED on the B140-004
will illuminate to indicate power is being received from the external
power supply. The Green RJ45 LEDs on the B140-002 will illuminate
to indicate power is being received from the external power supply.
Using Cat5e/6 cable, connect one of the RJ45 output ports on the
local unit to the RJ45 input port on the B140-1P0, B140-1A0,
B140-1P0-WP-1 or B140-1A0-WP-1 remote unit.
Repeat step 5 for each additional remote unit you are connecting.
B140-1A0 and B140-1A0-WP-1 only: Connect the external
power supply to the B140-1A0 or B140-1A0-WP-1 and plug it into
a Tripp Lite Surge Suppressor, PDU or UPS. The Green RJ45 LED
on the B140-1A0 and the Green LED on the B140-1A0-WP-1 will
illuminate to indicate that the unit is receiving power.
Repeat step 7 for each additional B140-1A0 or B140-1A0-WP-1 in
the installation.
15
11/3/2011 11:37:10 AM