Power connector
Description
Power connector
Before removing the power connector, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Bottom cover (see
5.
Remove the battery (see
Remove the power connector:
1.
Disconnect the power connector cable from the system board (1).
2.
Remove the Phillips PM2.0×3.0 screw (2) that secures the power connector cable to the computer.
3.
Lift the power connector from the computer (3).
Reverse this procedure to install the power connector.
58
Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Bottom cover on page
35)
Battery on page
41), and then remove the following components:
Spare part number
749612-001