Supervisor Engines - Cisco CAtalyst 4500 Series Installation Manual

Supervisor Engines

Supervisor Engines
Note
Table 1-5 Supervisor Engine Features
Feature
Data path and control
Management functions
MAC addresses supported
VLANS
Port aggregation
SNMP
Catalyst 4500 Series Switches Installation Guide
1-20
The following supervisor engines are available for the Catalyst 4500 series
switches:
Supervisor Engine II (WS-X4013)
•
Supervisor Engine II-Plus (WS-X4013+)
•
Supervisor Engine II-Plus TS (WS-X4013+TS)
•
Supervisor Engine II-Plus 10GE (WS-X4013+10GE)
•
• Supervisor Engine III (WS-X4014)
Supervisor Engine IV (WS-X4515)
•
Supervisor Engine V (WS-X4516)
•
Supervisor Engine V-10GE (WS-X4516-10GE)
•
E-series supervisor engines may in some cases also work on Catalyst 4500 series
systems, refer to the installation note for your supervisor engine for details.
The Catalyst 4500 series supervisor engines have the following features:
Description
Available on all network interfaces
Interface monitoring
Environmental status
SNMP and console/Telnet interface
32,768 per system (Cisco IOS only)
Up to 4,096 VLANs with IEEE 802.1Q VLAN tagging on all ports and
VLAN Trunking Protocol (VTP)
1
PAgP for 100-Mbps and 1000-Mbps EtherChannel
Full implementation, including entity-MIB, all relevant standard MIBs,
and all relevant Cisco MIBs
Chapter 1
(Figure 1-5)
(Figure 1-6)
(Figure 1-7)
(Figure
(Figure 1-9)
(Figure 1-10)
(Figure 1-11)
(Figure 1-12)
Product Overview
1-8)
78-14409-08