Accessing Help Online; For More Information - Cisco Catalyst 3560-C Getting Started Manual

Accessing Help Online

For More Information

Catalyst 3560-C and 2960-C Switch Getting Started Guide
22
To reset the switch in one of these ways:
Press the Reset button on the rear panel.
•
Press and hold the Mode button. The switch LEDs begin blinking after about
•
3 seconds. Continue holding down the Mode button. The LEDs stop blinking
after 7 more seconds, and the switch reboots.
The switch now behaves like an unconfigured switch. You can enter the switch IP
information by using Express Setup as described in the
section on page 4.
First look for a solution to your problem in the troubleshooting section of the
switch hardware installation guide or the switch software configuration guide on
Cisco.com. You can also access the Cisco Technical Support and Documentation
website for a list of known hardware problems and extensive troubleshooting
documentation.
For more information about the switch, see these documents on Cisco.com:
Release Notes for the Catalyst 3560-C Switch
•
Release Notes for the Catalyst 2960-C Switch
•
Catalyst 3560-C and 2960-C Switch Hardware Installation Guide
•
Regulatory Compliance and Safety Information for the Catalyst 3560-C and
•
2960-C Switches
Catalyst 2960 and 2960-S Switch Software Configuration Guide
•
Catalyst 2960 and 2960-S Switch Command Reference
•
• Catalyst 3560 Switch Software Configuration Guide
Catalyst 3560 Switch Command Reference
•
Catalyst 3750, 3560, 3550, 2975, 2970, 2960, and 2960-S Switch System
•
Message Guide
Catalyst 3560-C and 2960-C Switch Getting Started Guide
"Running Express Setup"
OL-23802-02