Resetting The Switch; Accessing Help Online; For More Information - Cisco Catalyst 2360 Getting Started Manual

Troubleshooting

Resetting the Switch

Follow these steps to return your switch to the factory default settings. These are reasons why you might
want to reset the switch:
•
•
•
Resetting the switch deletes the configuration and reboots the switch.
Caution
To reset the switch:
Press and hold the Mode button. The switch LEDs begin blinking after about
3 seconds. Continue holding down the Mode button. The LEDs stop blinking after 7 more seconds, and
then the switch reboots.
The switch now behaves like an unconfigured switch. You can enter the switch IP information by using
Express Setup as described in the

Accessing Help Online

First look for a solution to your problem in the troubleshooting section of the switch hardware
installation guide or the switch software configuration guide on Cisco.com. You can also access the
Cisco Technical Support and Documentation website for a list of known hardware problems and
extensive troubleshooting documentation.

For More Information

For more information about the switch, see these documents on Cisco.com:
•
•
•
•
•
•
•
•
•
•
Catalyst 2360 Switch Getting Started Guide
18
You installed the switch in your network and cannot connect to it because you assigned the wrong
IP address.
You want to clear all configurations from the switch and assign a new IP address.
You want to reset the password on the switch.
Catalyst 2360 Switch Getting Started Guide
Catalyst 2360 Switch Hardware Installation Guide
Regulatory Compliance and Safety Information for the Catalyst 2360 Switch
Installation Notes for the Catalyst 2360 Switch Power Supply Module
Installation Notes for the Catalyst 2360 Switch Reversible Fan Module
Release Notes for the Catalyst 2360 Switch
Catalyst 2360 Switch Software Configuration Guide
Catalyst 2360 Switch Command Reference
Catalyst 2360 Switch System Message Guide
Cisco IOS Software Installation Document
"Running Express Setup" section on page 3.
OL-22149-02