Cisco Catalyst 3560-C Getting Started Manual page 6

Step 5 Connect a Category 5 or 6 Ethernet cable to
any 10/100 or 10/100/1000 Ethernet downlink
port (such as port 1) on the switch front panel.
Connect the other end of the cable to the
Ethernet port on your PC.
Before going to the next step, wait until the
port LEDs on the switch and your PC or
laptop are green or blinking green. The green
port LEDs mean a successful connection.
Troubleshooting:
If the port LEDs do not turn green after about
30 seconds, make sure that:
You connected the Ethernet cable to one
•
of the downlink switch ports (not to an
uplink port such as the dual-purpose
port).
You are using an undamaged Category 5
•
or 6 Ethernet cable.
The other device is turned on.
•
Step 6 Enter the IP address 10.0.0.1 in a web
browser, and press Enter.
When prompted, enter the default password,
cisco.
The switch ignores text in the
Note
username field.
The Express Setup window appears.
Troubleshooting:
If the Express Setup window does not appear,
make sure that any pop-up blockers or proxy
settings on your browser are disabled and that
any wireless client is disabled on your PC or
laptop.
Catalyst 3560-C and 2960-C Switch Getting Started Guide
6
Catalyst 3560-C and 2960-C Switch Getting Started Guide
SYS T
STA T
D PLX
1
M O D E SPD 2
3
Se ri es
PoE 4
5
PD 6
CO NSO
7
LE
8
PO W ER
O VER
ETH ERN
ET
1
2
PD
OL-23802-02