Setting Up Your Air Purifier; Air Purifier Parts - Hunter QuietFlo 30145 Instruction Manual And Installation Instructions

Setting Up Your Air Purifier

1. Remove your air purifier from the box and take it out of the clear plastic protective
bag.
2. Place your QuietFlo™ Air Purifier on a firm, flat floor.
3. Before turning the Air Purifier 'on', you need to open the front grill. Refer to Figure 1.
4. The HEPA filter is already installed in the correct position, but you need to confirm
that it is fully inserted. To remove, grasp the edge of the filter frame and pull it
forward. Notice the orientation of the flaps and seal, which should be pressed firmly
into the filter opening.
5. The carbon pre-filter is mounted inside the front grill with "hook" tape. Confirm
that it covers the grill vents. Refer to Figure 2.
6. Place the filter installation reminder sticker on the inside edge of the front grill.
Circle the month and write the year of installation for the pre-filter and HEPA filter.
7. Replace the filter and front grill. Be sure that the bottom grill tabs are in position
first, and then push the top of the grill forward until it is closed. The unit is now
ready for normal operation. NOTE: This unit will not operate unless the door is
placed in the correct position.
8. Plug the unit into a 120V electrical outlet.
HEPA
FILTER
PRE-
FILTER
FRONT
GRILL
41478-01 4/23/2002

AIR PURIFIER PARTS

Represents all models.
TO OPEN
FRONT GRILL
FIGURE 1
3
HOOK
TAPE
GRILL
VENTS
HOOK
TAPE
FIGURE 2
© 2002 Hunter Fan Company