Table of Contents
Advertisement
®
SETTING UP YOUR AIR PURIFIER
1. Remove your air purifier from the box and take it out of the clear
plastic protective bag.
2. Place your QuietFlo™ Air Purifier on a firm, flat surface.
3. Before turning the Air Purifier ON, you need to open the front grille.
For Models 36114/36115/36144/36145: To release the front grille,
press the tabs until the front grille slides easily over the tabs. Refer to
Figures 2a on page 5.
For Models 36259/36260/36394/36395: To release the front grille,
place your fingers behind the tabs and pull forward. Refer to Figures
3a and 3b on page 6.
4. The HEPA filter is already installed, but you should confirm that it has
not shifted during shipment. Check the position of the HEPA filter
by pressing firmly on all four corners to ensure that it is fully inserted
into the filter opening.
5. The carbon pre-filter is mounted inside the front grille with hook
tape. Confirm that it covers the grille vents. Refer to Figures 2b, 3c,
and 3d on pages 5 and 6.
6. Find the filter installation reminder sticker on the inside edge of the
front grille or unit. Circle the month and write the year of installation
for the pre-filter and HEPA filter.
7. Replace the front grille. Be sure that the bottom grille tabs are in
position first, and then push the top of the grille forward until it is
closed. The unit is now ready for normal operation.
Note: The unit will not operate unless the door is placed in the correct
position.
8. Plug the unit into the proper voltage outlet
Hunter Model No.
4
36114
36144
120 V 60 Hz
36259
36394
36115
36145
220-240 V 50 Hz
36260
36395
Rating
41481-01 10-5-2001
Advertisement
Table of Contents
