Advertisement
Setting Up Your Air Purifier
1. Remove your air purifier from the box and take it out of the clear plastic protective bag.
2. Place your QuietFlo™ Air Purifier on a firm, flat surface.
3. Before turning the Air Purifier 'on', you need to open the front grille. To release the front
grille, place your fingers behind the tabs and pull forward. Refer to Figure 1A or 1B.
4. The HEPA filter is already installed in the correct position, but you need to confirm that
it is fully inserted. To remove, grasp the edge of the filter frame and pull it forward.
Notice the orientation of the flaps and seal, which should be pressed firmly into the filter
opening.
5. The carbon pre-filter is mounted inside the front grille with "hook" tape. Confirm that it
covers the grille vents. Refer to Figure 2A or 2B on page 4.
6. Place the filter installation reminder sticker on the inside edge of the front grille. Circle
the month and write the year of installation for the pre-filter and HEPA filter.
7. Replace the filter and front grille. Be sure that the bottom grille tabs are in position first,
and then push the top of the grille forward until it is closed. The unit is now ready for
normal operation. NOTE: This unit will not operate unless the door is placed in the cor-
rect position.
8. Plug the unit into a 120V electrical outlet.
HEPA
FILTER
PRE-
FILTER
FRONT
GRILLE
HEPA
FILTER
PRE-
FILTER
FRONT
GRILLE
FORM 41450-01 6/2000
AIR PURIFIER PARTS
QuietFlo™ 210
FIGURE 1A
QuietFlo™ 260
FIGURE 1B
3
RECESS FOR
FINGERS TO
PULL OPEN
FRONT GRILLE
RECESS FOR
FINGERS TO
PULL OPEN
FRONT GRILLE
©2000 HUNTER FAN CO.
Advertisement
