Kohler Command CV17 Service Manual page 82

Reassembly
Install External Governor Controls
1. Install governor lever onto governor cross shaft.
2. Make sure throttle linkage is connected to governor
lever and throttle lever on carburetor.
Two-barrel carburetor models: Move control panel
into position on blower housing and connect choke
linkage into bushing/lever from backside. Make
certain that control shaft offset is back and towards
cylinder side 2. Connect throttle linkage and spring
to governor lever.
3. Move governor lever toward carburetor as far as it
will go (wide-open throttle) and hold in position.
4. Insert a nail into hole on cross shaft and rotate shaft
counterclockwise as far as it will turn, then torque
nut to 6.8 N·m (60 in. lb.).
5. Reconnect lead wire to fuel shut-off solenoid (if
equipped).
6. Install lower support control bracket (if equipped with
a control panel).
7. Secure control panel to blower housing with screws
(if not equipped with heavy-duty air cleaner).
8. Assemble throttle control shaft to control bracket.
9. Assemble choke control to control bracket.
10. Connect Oil Sentry
™
governor spring to governor lever. See appropriate
charts.
Install Throttle and Choke Controls
Throttle and Choke Components
H
G
F
E
Choke Lever
A
Throttle Actuator
C
Lever
Choke Return Spring
E
Flat Washer(s)
G
Screw
I
1. One-Barrel Carburetor Models: Connect choke
linkage to carburetor and choke actuator lever.
2. One-Barrel Carburetor Models: Install standard
throttle control bracket and air cleaner support
bracket (if used) to cylinder heads using screws.
Torque screws to 10.7 N·m (95 in. lb.) into new
holes, or 7.3 N·m (65 in. lb.) into used holes.
82
Indicator light wires. Attach
I
A
B
C
D
Throttle Control
B
Lever
Lock Nut
D
Speed Control
F
Bracket
Wave Washer
H
KohlerEngines.com
3. Connect governor spring from throttle control bracket
to appropriate hole in governor lever, as indicated in
applicable chart. Note that hole positions are
counted from pivot point of governor lever.
Governor Lever Hole Position (6 mm)
H
G
F
D
C
Governor Lever
A
Hole 1
C
Hole 3
E
Hole 5
G
6 mm Governor Lever and Hole Position/RPM Chart
High Idle Governor Lever
RPM Hole No.
3801-4000
3601-3800
3451-3600
3301-3450
3101-3300
2951-3100
2800-2950
3750*
3150*
*5% Regulation (others 10%)
8 mm Governor Lever and Hole Position/RPM Charts
E
C
Governor Lever
A
Hole 2
C
Hole 4
E
E
A
B
Governed Idle Hole
B
Hole 2
D
Hole 4
F
Hole 6
H
Governor
Spring Color
Code
6 Clear
5 Clear
4 Clear
3 Clear
5 Purple
4 Purple
3 Purple
4 Clear
4 Purple
D
A
B
Hole 1
B
Hole 3
D
24 690 07 Rev. B