Kohler Command CV17 Service Manual page 79

3. Install each ignition module to crankcase bosses
with screws (hex fl ange or allen head, based on
model). Slide modules up as far away from fl ywheel
as possible and snug screws to hold them in that
position.
4. Rotate fl ywheel to position magnet directly under
one ignition module.
5. Insert a 0.30 mm (0.012 in.) fl at feeler gauge
between magnet and ignition module. Loosen
screws enough to allow magnet to pull module
against feeler gauge.
6. Torque screws to 4.0-6.2 N·m (35-55 in. lb.).
7. Repeat steps 4 through 6 for other ignition module.
8. Rotate fl ywheel back and forth checking for
clearance between magnet and ignition modules.
Make sure magnet does not strike modules. Check
gap with a feeler gauge and readjust if necessary.
Final air gap: 0.280/0.330 mm (0.011/0.013 in.).
Install Intake Manifold
Torque Sequence
3
1
NOTE: If wires were disconnected from ignition modules
on engines with SMART-SPARK
leads and seal base of terminal connectors with
GE/Novaguard G661 or equivalent dielectric
compound. Beads should overlap between
terminals to form a solid bridge of compound. Do
not put any compound inside terminals.
24 584 15-S ignition modules have a separator
barrier between terminals. On these modules,
seal base of terminals, but it is not necessary to
have overlapping beads of sealant between
connections.
1. Install intake manifold and new gaskets or O-rings
(plastic manifold), with wiring harness attached, to
cylinder heads. Slide any wiring harness clips onto
appropriate bolts before installing. Make sure
gaskets are in proper orientation. Using sequence
shown, torque screws in two increments, fi rst to
7.4 N·m (66 in. lb.), then to 9.9 N·m (88 in. lb.).
2. Connect kill lead to tab terminal on standard ignition
modules.
24 690 07 Rev. B
Install Breather Cover and Inner Baffl es
Breather Cover Torque Sequence
RTV sealant was used on early models between
breather cover and crankcase. A gasket with imprinted
sealant beads is now used and recommended. Install as
follows.
4
1. Be sure sealing surfaces of crankcase and breather
2
2. Check to make sure there are no nicks or burrs on
, reattach
™
3. Position breather gasket and cover on crankcase.
4. Install inner baffl es using remaining screws and
Install Blower Housing and Outer Baffl es
Wires on Starter Side of Engine
KohlerEngines.com
1
4
cover are clean of old gasket material or RTV
sealant. Do not scrape surfaces as this could result
in leakage.
sealing surfaces.
Install fi rst screws in locations 3 and 4 as shown.
Finger tighten at this time.
fi nger tighten. Do not torque screws at this time; they
will be tightened after blower housing and outer
baffl es are installed.
Reassembly
3
2
79