Kohler Command CV17 Service Manual page 81

3. For covers requiring RTV sealant, apply a 1.5 mm
(1/16 in.) bead to sealing surface of both cylinder
heads, install a new cover gasket on each, then
apply a second bead of sealant on top surface of
gaskets. For O-ring type covers, install a new O-ring
in groove of each cover. Do not use gaskets or RTV
sealant.
4. Position covers on cylinder heads. Locate cover with
oil separator hole on cylinder 1. If loose spacers
were used, insert a spacer in each screw hole.
Install screws in each cover and fi nger tighten.
5. Torque valve cover fasteners to proper specifi cation
using sequence shown, unless screws also attach
heavy-duty air cleaner main support bracket or other
components. Installation and torquing of screws will
be performed after these parts are installed.
Torque Specifi cations-Covers
Gasket/RTV
Black O-ring
w/shoulder screws
w/screws and spacers
Yellow or Brown O-ring
w/integral spacers
Install Carburetor
Explosive Fuel can cause fi res and severe
burns.
Do not fi ll fuel tank while engine is hot or
running.
Gasoline is extremely fl ammable and its vapors can
explode if ignited. Store gasoline only in approved
containers, in well ventilated, unoccupied buildings,
away from sparks or fl ames. Spilled fuel could ignite
if it comes in contact with hot parts or sparks from
ignition. Never use gasoline as a cleaning agent.
1. Install a new carburetor gasket. Make sure all holes
align and are open.
2. Install carburetor, throttle linkage, choke linkage, and
governor lever as an assembly. If a plastic intake
manifold is used and/or carburetor is equipped with
a fuel solenoid, reconnect ground and main leads.
24 690 07 Rev. B
3.4 N·m (30 in. lb.)
5.6 N·m (50 in. lb.)
9.9 N·m (88 in. lb.)
6.2 N·m (55 in. lb.)
WARNING
KohlerEngines.com
Control Panel Components
A
D
D
B
E
F
G
J
Nut
A
Flat Washer
C
Carburetor
E
Governor Lever
G
Throttle Shaft
I
Spacer
K
Linkage Spring
M
Carburetor Gasket
O
Choke Lever
Q
Throttle Shaft Spring
S
Reassembly
B
L
C
S
R
C
Q
P
O
N
M
H
I
C
K
L
C
B
Lock Nut
B
Control Bracket
D
Air Cleaner Gasket
F
Governor Spring
H
Bracket
J
Throttle Control
L
Lever
Throttle Linkage
N
Choke Linkage
P
Screw
R
81